TL 18095 - The use of polyvinyl alcohol hydrogel implants in the lesser metatarsal heads. Is it safe?

a cadaveric study

Authors

  • Alexandre Leme Godoy-Santos Instituto de Ortopedia e Traumatologia, Hospital das Clínicas, Faculdade de Medicina, Universidade de São Paulo, São Paulo, SP, Brazil
  • Cesar de Cesar Netto Hospital for Special Surgery, New York City, US
  • Lauren Roberts Hospital for Special Surgery, New York City, US
  • Taylor Cabe Hospital for Special Surgery, New York City, US
  • Jonathan Deland Hospital for Special Surgery, New York City, US
  • Mark Drakos Hospital for Special Surgery, New York City, US

DOI:

https://doi.org/10.30795/scijfootankle.2019.v13.1057

Keywords:

Lesser metatarsal, Arthritis, Cadaveric study

Abstract

Introduction: Treatment of lesser toe metatarsophalangeal joint (MTPJ) arthritis is challenging, and surgical options are scarce. The use of synthetic polyvinyl alcohol hydrogel implants in the treatment of lesser MTPJ arthritis may provide symptomatic relief. An essential technical limitation is that only 8 mm and 10 mm implants are currently available, potentially limiting their use in the lesser metatarsals. Objective: to evaluate the average dimensions of the lesser metatarsal heads using CT scans and anatomical dissections and to perform drilling of the heads, aiming to assess the largest implant that could be safely used. Methods: The height and width of all lesser metatarsals were measured on CT and during anatomic dissection. Sequential reaming of the second to fourth metatarsals was performed. The maximum reaming size, largest implant inserted, and failure of the metatarsal head were recorded. Metatarsal head sizes were compared, and a multiple regression analysis evaluated measurements that influenced maximum drilling and implant size. Results: CT and anatomical measurements demonstrated a significant correlation (ICC range, 0.63 to 0.85). Mean values for the height and width of the metatarsal heads respectively were as follows: second (14.9 mm and 9.9 mm), third (14.8 mm and 8.8 mm), fourth (14.0 mm and 8.7 mm) and fifth (12.3 mm and 9.3 mm). All the second, third and fourth metatarsal heads could be safely drilled up to 7.5 mm, preserving an intact bone rim. During 80% of the time, the heads could be safely drilled up to 8.0 mm. The height of the metatarsal heads was the only factor to significantly influence the size of maximum reaming and the introduced implant. In 20%, 40% and 50% of the second, third, and fourth metatarsal heads, respectively, neither 8 mm nor 10 mm PVAH implants could be used. Conclusion: Our cadaveric study found that even though the majority of the lesser metatarsal heads could be safely drilled up to 8 mm, the smallest PVAH implant size currently available in most countries (8 mm) could be inserted in most of the second but only in about half of the third and fourth metatarsal heads. The remaining bone rim around the inserted implants was considerably thin, usually measuring less than 1 mm. To optimize the use PVAH in lesser metatarsal heads, smaller implant options are needed.

Published

2019-11-11

How to Cite

Godoy-Santos, A. L., Netto, C. de C., Roberts, L., Cabe, T., Deland, J., & Drakos, M. (2019). TL 18095 - The use of polyvinyl alcohol hydrogel implants in the lesser metatarsal heads. Is it safe? a cadaveric study. Scientific Journal of the Foot & Ankle, 13(Supl 1), 78S. https://doi.org/10.30795/scijfootankle.2019.v13.1057